Can Floor Tile Have Air Pockets

After determining the root cause of the buckling tile it s possible to fix all problem areas and protect your investment from future damage.

Can floor tile have air pockets.

Most laminate specs for a 1 4 inch expansion joint on all walls. Someone once told me that these bubbles are created by the adhesive releasing gases and would soon go away. Securing loose ceramic or clay tiles before they break will save time and money down the road. If the floor seems to be buckling or lifting the problem most likely is that it wasnt installed with the proper expansion around the entire area.

In your report you say that more than 25 of a floor tapping with a hollow sound can indicate a problem. I took a picture when the contractor removed 27 tiles in the kitchen to try to get the edges to line up better from what i see it appears that 5 or so of them came out whole so we re trying to figure out whether the entire floor needs to come out and be put back in. I have seen many floors laid over the years and laid a few myself. All of the floors that i saw and laid myself laid flat with out air bubbles after a couple of days.

Ceramic or porcelain tiles over 12 call for just enough mud on the back of the tiles to improve and complete the bond to the notches on the floor avoiding air pockets and voids. However some bubbles may remain under the vinyl even when you finish the installation. Loose floor tiles occur if the original adhesive doesn t seal properly or if the grout is chipped or uneven allowing moisture to get under the tile. Laminate should not have an air pocket in it.

I have also noticed these air bubbles under the floor with some concern. Bubbles can form during the installation of the sheet vinyl flooring but they can then vanish when you run a roller over the floor. Needless to say if we can avoid removing tile and saving our house from the absolute mess that seeps through protective plastic barriers we will. Any threshold strips and cut back the flooring to allow a gap of at least 6 8 mm up to 12mm cutting back laminate floor in situ can be done using a multimaster tool or if you have the patience a chisel.

Sounds to me like your guys methods increases air pockets and voids between the tile and the thin set applied to the floor. You will need to remove such air bubbles manually. If the tile is well bonded i e. Properly diagnosing the cause of the problem is essential to ensure any fix will have a long lasting effect.

Fix a loose ceramic floor tile before the tile breaks. Chains or special sounding devices can be used for larger areas. If you hear a lower pitched or a hollow sound this can indicate that tiles have debonded or were never bonded somewhere within the tile assembly. My floor is tiled to the skirting.

Attached to the concrete substrate it will have a high pitched sound.