Can I Glue Hardwood Flooring To Wafer Baord

We hope someone can give us advice.

Can i glue hardwood flooring to wafer baord.

Using a standard nail gun to install the floor was out of the question particle board isn t structurally sound enough to bite nails. Most engineered wood floors are milled with. While installing be sure to do small areas at a time. If this type of underlayment is present it will have to be removed when planning to install a nail or glue down hardwood floor.

Particle board can absorb excessive moisture is very brittle and does not hold nails very well. The subfloor is osb on joists 16 o c. Last year we installed solid oak hardwood floor in our main bedroom and family room. Do not pre spread the adhesive over the entire sub floor as it will dry before you get to that area.

The other concern has always been that water in a concrete slab will be absorbed by wood flooring. Hardwood can make for a durable and beautiful floor but small mistakes in the subflooring or installation can wreak havoc and buckling squeaky uneven floors can all result from poor installation. We want to remove the carpet in our living dining room approximately 50 x 15 plus adjacent hallway 20 x 4 and replace it with engineered hardwood flooring. Flooring straps can also be used to hold the boards into place to ensure they do not move around while the glue is drying.

That option is floating a floor over top of the subfloor. The adhesive is spread on an area of the subfloor where the boards are going to be adhered to using a specialized trowel. To our dismay when we ripped up the old carpet we found that the whole subfloor was covered with particle board. Stop when you have about 5 feet of flooring remaining to be laid or when you don t.

While this is not a definitive guide to hardwood installation over osb panels there are some important points to ponder. There is no need to glue the planks together as they are fully bonded to the subfloor. Once you have decided to use the glue down floor method make sure that you leave a large enough expansion gap depending on the hardwood product you chose from the wall to allow the wood to contract and expand. But don t worry engineered hardwood floors are great for several reasons.

The only limitation is the slabs must be above or on grade. Installations of solid wood are never recommended below grade. These pros and cons should be considered when deciding which floor is best for your home and what will be the best long term outcome for your home. These products regardless of species thickness or width can be glued down successfully over concrete or gypsum based sub floors.

Place the hardwood flooring planks on top of the adhesive and push them together. The reason you can only float a floor over particle board is because nails won t hold in the particle board and glue will ruin the particle board.