Tiny particles of dirt and sand tracked into the room on shoes can dig into the finish of the floor causing dents divots or even scratches giving the bamboo a faded look.
Can u stain bamboo flooring.
Over time bamboo floors may become discolored scratched or marred.
You will need to sand off the existing finish on the floor.
If you find that the bamboo is not taking the stain wipe off the extra stain with a rag and allow the area to dry.
Its density gives it more protection against denting and scratching.
You can both stain and finish bamboo plywood just as you would ordinary plywood.
Bamboo can be discolored if it gets too much direct sunlight so it is best to use shades or blinds in rooms that get direct sunlight.
Unlike traditional floor strand woven bamboo flooring rarely need to be refinished.
Pay attention to the node areas.
Bamboo flooring design howstuffworks acton 5 engineered bamboo flooring how to protect your floors from damage plyboo bamboo floor new can you stain a 3 stained bamboo jacobean bamboo floor wikipedia.
How often to clean bamboo flooring.
All bamboo flooring is pre finished and that being said not all bamboo flooring is solid.
Classic or traditional bamboo can be sanded down and be refinished easily.
In most cases the bamboo floor will never need to be restained once installed.
Use a floor polisher and sanding screen to remove this top layer.
Try re sanding the area and then re stain.
Spills and wet spots will need to be cleaned up immediately so they don t stain the floor or cause it to warp.
How to stain bamboo floor.
If you are refinishing your bamboo floor then you will need to remove the top layer of finish in order to stain your bamboo.
The answer is yes.
Luckily the surface of this material can usually be refinished by sanding it down and then reapplying sealing coats.
In general any stains and finishes which work well with medium density hardwoods work equally well with solid bamboo plywood.
Use circular motions with a sponge or rag to stain the bamboo.
If your bamboo is in good shape then you will only need to screen the top layer.