Can You Apply Oil Based Stain To Water Popped Floor

Hope you end up with a color you love.

Can you apply oil based stain to water popped floor.

The easiest way to tell if stain is oil or water based is to look on the can and see what is needed to clean the brush afterwards. Products like parks water based polyurethane for floors can be applied over oil based poly. If you are sanding a floor for a clear finish some call it a natural finish you must sand the floor at least 3 times. Allow to dry two hours.

Walking on floors putting drop clothes or furniture on floors. Oil based will require mineral spirits lacquer thinner or another chemical to clean up or thin. Apply a thin coat first that will dry and harden faster. But the water base finishes always suggest a soap and water clean up.

It s okay if you apply the stain on the floors the following day or even a few days later as long as nothing happens to the floors to cause the floors to close up e g. Whereas oil based polyurethane s require mineral spirits naphtha or paint thinner for clean up. This helps to protect and preserve the wood. Sometimes you re working on a project and you realize you ve got some oil stain that you want to use or finish up or simply that you d applied an oil based stain but you re wanting to use your emtech water based sealer for example ush 3000 ultraseal water based shellac sealer or em1000 universal sanding sealer on top of the stain and you wonder if you can.

However you must buff sand the entire floor to break the existing gloss and completely remove the sanding dust before application. If you are using a sprayer that has been used for oil based or lacquers clean the unit thoroughly and rinse with warm water before using. If you re using a waterbased stain buffing usually is not recommended if you water popped walk on the area you already stained as you apply the stain so you don t crush the grain on the unstained floor step 5. That floor you asked about is my living room floor it s 25 ebony 75 natural on water popped red oak with an oil based polyurethane applied.

Allow the natural stain to dry 1 hour before applying your final stain color. Apply top coat of water based polyurethane with a clean paintbrush and floor finish applicator. Next wipe off the excess stain with a rag or with a clean white pad on the buffer for oil based stains only. Water based will only require soap and water to clean up or water to thin.