In fact most carports are installed over grass stones or even dirt.
Carport roof 4x4 attach to concrete.
Can one use asphalt or gravel for the area the car sits.
However if you are interested in a concrete pad most concrete contractors will usually recommend pouring a concrete pad or concrete slab 3 4 wider and the same length as the metal carport building frame you order.
Mark the location of the holes in a metal post bracket on the concrete.
Anyone planning carport construction will know or will eventually discover that setting carport posts is the primary key to the stability and the durability of the carport.
To attach the bracket to the concrete properly if it is not concrete and actually black top the bracket will have to be.
A carport should be at a minimum seven feet from the ground to the lowest rafter so ensure that the posts have adequate height.
This is because this car park has an actual plan with a good list of ingredients and instructions too.
Using home depot materials a makita drill and red head anchors to a.
Insert lead shields into the holes in the concrete.
This carport comes with a unique sloping roof.
Allow the concrete time to cure according to manufacturer s directions.
No matter how secure your carport roof is if it is not supported by sturdy straight posts there is an increased possibility that your carport could collapse.
You can surface mount a post that will have more than one point of support such as a post that attaches to both a concrete slab and a covered roof or a post that supports a handrail that s also attached to a house.
I was told the carport flooring must be cement with 42 frost footings around the perimeter.
Need to know if a cement flooring is required if the carport is attached to house.
You drill into the concrete and insert concrete screws or anchors.
Actually the wooden attached carport to house only holds one car but you can change it.
And each post supporting the roof of the carport must also be in ground below frost line 42.
Use lag bolts or screws to attach the metal post bracket to the concrete.
Anchoring 4x4 post to concrete pads.
Drill holes into the concrete that are the right diameter for lead shields using a masonry bit in a hammer drill.
Buy a bracket that fits a 4x4 that you will attach it to the concrete.
Attaching wood posts to concrete using a simpson strong tie e z base fence post base.
Attach the posts to the anchors with nails or structural screws and a power drill.