Caulking Eifs Panel And Roofing Membrance Construction Illustrated

Chapter 8 construction details provides technical information concerning the design and installation of construction details for quality spf roof systems.

Caulking eifs panel and roofing membrance construction illustrated.

Originally eifs was designed as a perfect barrier system. Morrow ga 30260 800 294 3462 eifs industry members association guide to eifs construction these drawings and comments are for general information only and eima specifically disclaims any design or construction intent or responsibility. An exterior insulation and finish system a k a. That is one which provides waterproofing protection at the exterior face of the cladding.

Construction details are provided for the following spf roof system types. Eifs was introduced in the us in the 60 s and transitioned from commercial buildings to residential homes. Eifs today are one of the most tested and well researched claddings in the construction industry. This article was originally published as part of an aia ces discovery course.

This introduction is intended to supplement the special notes on the individual construction details. The rate of wetting of a building assembly is a function of exposure design construction and operation maintenance. The eifs exterior insulation and finishing system system shall be installed with the application instructions. Min base coat thickness shall be sufficient to fully embed the mesh.

Parex eifs details csi section 07 24 00 the drawings and any related notes or text contained thereon are based upon typical requirements of parex exterior insulation and finish systems and are published strictly as a guide for architectural and construction industry professionals to illustrate typical or general design conditions. Sythetic stucco is an exterior wall cladding system comprised of insulation boards attached to a substrate covered with a reinforced base coat and a textured protective finish coat. Just as all cladding systems eifs are sensitive to the frequency and severity of rain. 3000 corporate center dr.

Eifs is a lightweight synthetic. Research conducted by the oak ridge national laboratory and supported by the department of energy has validated that eifs are the best performing cladding in relation to thermal and moisture control when compared to brick stucco and. The principal wetting mechanism for eifs assemblies is rain.