Can I Seal Wood Floor Before Installation

When nailing down a wood floor the subfloor should be flat to within 1 4 in 10 or 3 16 in 6.

Can i seal wood floor before installation.

Installing a hardwood floor over a concrete slab even if your home was built on a concrete slab you can still enjoy the beauty and charm of hardwood floors. You should always sand the floor before sealing even if you re installing new unfinished flooring boards and it s important to seal as soon as possible after sanding whether you use penetrating. It is the responsibility of the flooring installer to assess and address substrate flatness before installation. Densifiers are another type of floor sealant that prevent moisture from wicking to the surface of the floor although a good vapor barrier installed under the slab may negate the need for this type.

Knowing how to stain and seal a hardwood floor properly pays off in having a beautiful finish and enduring protection. Before you can lay down floor leveling compound you need to seal it with a diluted pva poly vinyl adhesive mix or an acrylic sealer. Bring the wood into the room and allow it to sit for approximately 24 to 48 hours. Staining and sealing hardwood floors the right way whether you re refinishing refurbishing or stripping the wood floor results in years of enjoyment.

This will allow it to adjust to the surroundings before you nail it down. Now that the floor is prepped you re ready to add the compound. Experienced professionals pay close attention to managing moisture and minimizing wood floor expansion and contraction when preparing to install hardwood floors on concrete slabs. Is there a suggested measure i can take to seal the floor so spills don t ruin it.

Urethane and acrylic sealers are somewhat less expensive than epoxy and require less time to set before installing carpet. My agent was telling me that spills and moisture in the seams will cause the planks to swell because they re essentially sawdust. So damned if you do and damned if you don t. I bought a house with wood laminate flooring where the planks are pressed wood with a wood print veneer.

Which means you either need to sand down to raw wood and glue to that never a good idea or you lay down new plywood over the hardwood never a good idea if the hardwood can be salvaged later on and then glue to that. Sophie is correct with vinyl trapping moisture and causing the wood to rot. You should also consider allowing the wood to acclimate before you install it. Installation of a wood floor over the subfloor insinuates acceptance by the flooring installer.